Printers Ink Pad Is at the End of Its Service
Technology on the ane hand has made our life easier and effective only information technology too has some shortcomings. Equally they all are technical things, sometimes they do prove some errors or halt their operations. Whenever this blazon of situation happens, we must not panic and focus on the right and precise approach to the solution.
Epson is a renowned printer brand and is famous all over the earth for its reliable and quality printers. But one of its models the L210 often shows a cerise blinking calorie-free that is often termed as annoying by most of its users. Well for this fault, the reasons are many and you lot have to check them all. Moreover, after reading the reasons y’all will get to know straight that where you are making a mistake. So, let’s outset.
Issue i: Epson ink pad is at the end of its service life
This is the almost common type of issue faced by Epson users and is related to the Software of the printer. The software installed in the caput of the printer makes it stop working afterwards the printer prints a certain number of pages. The printer so shows the fault that it should be to the Service center for a fresh service.
Yet, this error could be tackled by using the
Epson Adjustment Program Software. Let’s see how you tin utilize this software to tackle the upshot.
-
Download
the Epson Adjustment Programme from
here
and Install information technology. - Afterward Installation, you lot volition see a similar screen like below and click the
Select
push.
- Here, select the Model Name equally
L210
and click okay.
- Now, from the master menu, click the
Particular Adjustment
Mode.
- A new window will get open, there click
waste product ink pad counter,and click
ok.
- Now you will exist directed to another window, here you have to
check
the
Main pad counter
and and then click
initialization.
A pop-up bulletin will show and you just have to click
ok.
After the process is done,
plow off
and
on
the printer and you are all set up.
Issue 2: Readjust newspaper bar is not in the place
The red light of the printer blinks the bulk of the time when the paper bare is non located in its ideal location. Then, ensure that the paper bar is located where it should exist and after correcting its place,
press
the
push the paper
button.
Consequence 3: Newspaper jam outcome
Follow these steps:
- Turn the printer off.
- Accept the change bar to the placement.
- Remove all the papers.
- Take the readjust bar back to its desired position.
- Refill the newspaper feeder with the papers.
- At last, switch the printer on and cheque if the trouble persists.
Outcome iv: Low ink trouble
The low ink in one of the cartridges of your printer could also lead to the blinking of the lite. And so, ensure that all of the cartridges have the right level of ink in them.
Issue five: Incorrectly installed ink cartridge
Installing the Ink cartridge in the incorrect manner is 1 of the common mistakes that is done by most of the folks. In case, do follow the following steps:
- Locate the ink switch on your printer.
- Observe the impress head to the ink cartridge. Likewise, supplant the placement if information technology is at the home placement.
- Reinsert the ink and remove the existing cartridge.
- Comport on with the ink cartridge process.
- Now bank check for the blinking fault.
We hope that these in a higher place steps have resolved the blinking issue. If the problem withal persists, you can contact Epson Support. We hope these steps assistance you in fixing this error. Good Luck 😊.
Article Comments