Adaptor Printer Canon Pixma Ip110 16 Volt

By using the printer every bit an access signal in an environment that does non have wireless LAN router or access point, or by using the printer as an access point temporarily in an surroundings that has wireless LAN router or access point, you tin can connect the printer to an external device such as a computer or a smartphone and impress from them.

This section describes how to enable the access betoken mode, the access point proper name of the printer, and the security setting.

Important

• Before using the printer with the access indicate way, confirm the usage restrictions so switch the printer to the access bespeak mode.

  
  
  
  Restrictions
  
  

• If you use the printer with the access point mode for the long time, information technology is recommended that you change the default admission betoken proper name and the default password to the combination of numbers and letters with the point of view of security.

How to enable the Admission Point Mode

Enable the access betoken mode following the procedure beneath.

1. Brand sure that the printer is turned on.

2. Printing and agree theWi-Fi
   push, then release the push when thePower
   lamp flashes 3 times.

   When the
   POWER
   lamp changes from flashing to lit, the access betoken style is enabled.

Notation

• To confirm the current access point mode setting of the printer, print out the network setting data.

  
  
  
  Press Out Network Setting Information
  
  

• You lot tin specify the access point proper name (SSID) and the security setting optionally.

Press with the Admission Indicate Mode

Print with the access indicate mode following the procedure below.

1. Connect an external device such as a computer or a smartphone to the printer via wireless LAN.

   Perform wireless LAN settings with your external device, so assign the access point proper noun specified for the printer every bit a destination.

   
   
   Note

   • For details on how to perform wireless LAN settings with an external device, refer to the device’southward didactics manual.

   • When a WPA2-PSK (AES) password is valid on the printer, entering the password is required to connect an external device to the printer via wireless LAN. Enter the password specified for the printer.

2. Start printing from an external device such as a computer or a smartphone.

   
   
   Note

   • For details on how to print from an external device such as a computer or a smartphone via wireless LAN, refer to the device’s or application’s instruction manual.

How to finish the Access Point Mode

In environments that the printer is connected with the estimator over the wireless LAN unremarkably, ready the printer to the wireless LAN connection when you terminate using the printer with the access point mode temporarily.

To enable the wireless LAN mode, press and hold the
Wi-Fi
button, then release the push button when the
POWER
lamp flashes four times.

When the
Ability
lamp changed from flashing to lit, the wireless LAN mode is enabled.

Note

• If you do not employ the printer with the access bespeak style or over the wireless LAN:

  The
  Wi-Fi
  lamp goes off past pressing and holding the
  RESUME/CANCEL
  push and then releasing the push button when the
  Ability
  lamp flashes 12 times.

  When the
  Wi-Fi
  lamp goes, the access point mode and the wireless LAN are disabled.

Setting of the Admission Betoken Manner

The initial value of the admission point mode is gear up every bit follows.

Annotation

• To confirm the current access indicate mode setting of the printer, print out the network setting information.

  
  
  
  Printing Out Network Setting Information
  
  

• Y’all tin can change the security setting and the password using IJ Network Tool.

  If yous alter the admission betoken mode setting of the printer, also alter the admission point setting of the external device such as a computer or a smartphone.